Capto Basics Course (Free)
In this Capto Basics course you will learn how to get started with the Capto Putting Sensor. After completing this course you will know how to:
- Connect the sensor to a device
- Attach the sensor to the shaft
- Record data with the Capto sensor
- Interpret the basic Capto data parameters
At the end of the course there will be an Assessment to test your knowledge.
This course on average will take about 2 hours to complete. You have to possibility to do this course all at once or divide it into parts an take it over several days, it's all up to you.
Introduction video (8m)
In this video you will get a full introduction of the Capto sensor.
Getting started (30m)
Attatching the sensor to the putter
The Capto sensor should Always be placed at the back of the shaft. let's say the players side of the shaft. This is also the case for left handed players.
Understanding the Data (60m)
In this video you can see an explanation of the Launch Data.
The Capto sensor can not see the ball, it can only measure the putter data, so the Launch Data are calculated data based on the measured values of the putter movement.
What is the maximum framerate of the Capto sensor
- 100 fps
- 200 fps
- 300 fps
- 400 fps
Do you always have to calibrate a target line to work with Capto?